BioHealing™ Conductive Gel 1L – Hydrating, Firming & Cooling Gel for Ultrasound, RF Cavitation, EMS, Beauty Machines & Professional Skin Treatment Procedures

Conductive gel is a water-based medium that allows energy (electrical or ultrasonic) to pass safely from beauty devices into the skin.

It:

• Improves energy transfer
• Prevents discomfort or “zapping”
• Helps device glide smoothly
• Enhances treatment results

 Machines Compatible with Conductive Gel

 Face & Body Devices

• Microcurrent (EMS facial toning)
• Radio Frequency (RF skin tightening)
• Ultrasound / Ultrasonic cavitation
• Galvanic facial machines
• TENS therapy devices
• Body slimming / fat cavitation machines

 These devices require gel to work properly — without it, results are weaker and can cause irritation

 How to Use Conductive Gel 

1. Clean Skin

• Start with clean, dry skin (no oils or makeup)

2. Apply Gel

• Apply a thin, even layer on treatment area
• Do NOT rub fully into skin (leave it slightly wet)

3. Start Device

• Turn on your machine and begin treatment
• Always keep device in contact with gel

4. Reapply if Needed

• If gel dries → apply more immediately
• Dry gel = discomfort + reduced results

5. After Treatment

• Wipe off remaining gel or massage into skin

 How Much Gel to Use 

 Face (Microcurrent / RF / Facial devices)

• Pea to coin size per area
• Full face: ~5–10 ml total

 Small Areas (Eyes, Jawline)

• Pea size per zone

 Body (Cavitation / RF / EMS)

• Generous layer (10–20 ml per area)
• Area examples: stomach, thighs, arms

👉 Rule:

• Too little = stinging / poor conductivity
• Too much = waste (no extra benefit)
• Use water-based gel only (NOT oils or creams)
• Always keep skin hydrated during treatment
• Never use device on dry skin
• Suitable for professional & at-home devices
• Safe for all skin types

 “This gel acts as an energy bridge, ensuring consistent conductivity between the device and skin for optimal performance, safety, and visible results.”

How to Use:
Apply a thin layer of conductive gel to clean skin before using your beauty device. Glide the device smoothly over the area, ensuring the skin remains hydrated throughout the treatment. Reapply gel if needed.

Compatible With:
Microcurrent (EMS), Radio Frequency (RF), Ultrasound Cavitation, Galvanic Facial Devices, TENS Machines & Body Slimming Devices.

Recommended Amount:

• Face: Small layer (5–10 ml total)
• Body: Generous layer (10–20 ml per area)